Dish / Bev Jtag Unit



Dish Network / Bell Expressvu Jtag Unit



Receiver Compatibility Chart:
Receiver Model# Works With This Jtag
DP301
501
2700
2800
3100
3700
3800
3900
4700
4900
5100
6000






What It Does

A Jtag is simply a device which communicates with your satellite receiver unit.
It acts as an interface between your computer and satellite receiver.



Uses

  • Backing up your receiver's memory for use in case of damage/catastrophe (MAKE BACKUPS!)          

  • Restoring backups in case of failure to return receiver to it's original state          

  • Extracting box keys from the receiver for your records          

  • Other custom uses          




How To Use It

Simply unplug your satellite receiver, connect the wires to your receiver's jtag port
as shown in the instructions, using either tape or just touching them with a soldering
iron (recommended), clip the alligator clip to any ground point of your receiver,
and plug the DB25 connector into your parallel port of your computer! It's that simple.
To make it communicate with your computer, you will need the program jkeys.
This will be emailed to you after your purchase.



What You Get

    1 Jtag unit for both Dish Network and Bell Expressvu systems          

    Support information emailed to you which shows wires to connect          

    You will be emailed the program jkeys after your purchase          










Clearance!


Dish / Bev Jtag Without Support - Ship To Worldwide      USD $34    Qty:  











Have a Question About This Gadget?

Submit your question below:

All Fields Are Required.

Name:

Email:

Question:




Privacy Policy  |  Terms of Use  |  About


© Copyright 2008 Techgadgetz.com, All rights reserved.